Неруйнівний контроль сталевих труб. Магнітопорошковий контроль безшовних і зварних сталевих труб для виявлення поверхневих несуцільностей

Доступність для покупця Доступний під замовлення
Код НД згідно з ДК 004 23.040.10, 77.040.20, 77.140.75
Позначення ДСТУ EN ISO 10893-5:2014
Мова Англійська
Метод прийняття Підтвердження
Чинний від 2016-01-01
Чинний до Ні
Чинність чинний
Зміни Ні
Сторінок на продаж Ні
Неруйнівний контроль сталевих труб. Магнітопорошковий контроль безшовних і зварних сталевих труб для виявлення поверхневих несуцільностей
Доступний під замовлення Щоб замовити, потрібно зв'язатися з представником УкрНДНЦ

Щоб придбати цей документ, будь ласка, скористайтесь формою нижче, або напишіть нам на адресу lyudmila.slepchenko@uas.org.ua чи зателефонуйте +38 (068) 526–41-63

Перейти до форми замовлення

Сфера застосування

This part of ISO 10893 specifies requirements for magnetic particle inspection of seamless and welded ferromagnetic steel tubes for the det ection of surface imperfections on the tube body and the end/bevel face at the ends. For the tube body, it specifies requirements for the detection of surface imperfections on all or part of the outside surface of tubes. However, by agreement between the purchaser and manufacturer, it can be applicable to the inside surface over a limited length from the ends of tubes, dependent on the tube diameter. In addition, this part of ISO 10893 can be used, as appr opriate, to locate the position of external surface imperfections detected by another non-destructive testing method (e.g. ultrasonic) prior to dressing of the tube surface, and to ensure complete removal of the imperfection after dressing is complete. For the end/bevel face at the end s of plain-end and beveled-end tubes, this part of ISO 10893 specifies requirements for the detection of laminar imperfections which can interfere with subsequent fabrication and
inspection operations (e.g. welding and ultrasonic inspection of the welds). This part of ISO 10893 is applicable to the detection of imperfections, other than laminar imperfections, on the end/bevel face. In this case, magnetization is applied in the direction essentially perpendicular to the orientation of the particular imperfections being detected. It can also be applicable to the testing of hollow sections